¶ Initial Print Setup
After unboxing the Guider 3 Ultra, follow these steps for the initial setup of the 3D printer:
Select the language and click [Next].
Check the platform and extruder before proceeding, following the on-screen prompts.
After clicking [Calibration], the platform will move up, and the left extruder will undergo auto Z-axis calibration first, followed by the right extruder.
Once calibration is completed, auto leveling will start.
Before loading, select the filament type for loading.
Note: Before loading, please ensure the filament is properly mounted. If unsure how to load, please refer to the Loading Filament Section.
After selecting the filament type, click [Load] and then follow the prompts to complete loading.
After loading is completed, click [Start printing] and select a model for printing.
Note: Please select the L_PLA_8m24s.gcode model for printing testing as the left extruder is the default extruder for loading filament during the startup guide.
To print the R_PLA_9m16s.gcode (rightextruder test model) or L+R_PLA_23m0s.gcode (dual-extruder test model), please first load filament for the corresponding extruder before starting the printing test.
Click [
].
The right side of the screen indicates the preparation status. Printing will start after preheating is completed.
After printing is completed, click [Ok], and the initial setup is completed.