¶ Initial Print Setup
After unboxing the Adventurer 5M Pro, follow these steps for the first startup of the 3D printer.
¶ 1.Select the language and click [Next].
¶ 2.Read the information prompts and click [Next].
¶ 3.Connect to Wi-Fi
¶ a) Turn on Wi-Fi and it will automatically search for available networks.
¶ b) Select the Wi-Fi network you want to connect and enter the password.
¶ c) Then, Wi-Fi is connected successfully.
¶ 4. Bind FlashMaker
what is FlashMaker?
¶ a) Use the FlashMaker App to scan the QR code for binding. After binding successfully, click [Next] to proceed.
¶ b) Click [Next] to skip this binding step.
¶ 5.The machine performs initial calibration.
¶ a）X, Y and Z-axis homing starts. Please ensure the platform nuts are removed before starting.
b) After the extruder and platform reach the target temperature, wiping starts.
Tip: The red box shows residues arising from wiping, which can be cleaned after calibration.
¶ c) After wiping, the platform will press firmly against the nozzle, and the nozzle temperature will drop to 120°C.
¶ d) It cools down to the target temperature for leveling and then performs a 25-point automatic leveling. After leveling is completed,
¶ it proceeds with XY vibration test. Please ensure the printer is on a stable surface before starting.
¶ e) When the countdown ends, after saving the XY vibration compensation value and 25-point value configurations,
¶ the extruder light will go off and then on again. Then it automatically jumps to the next page.
6. Follow the prompts to load filament
Note: For the initial setup, please use PLA filament for the first print. Here, PLA is used for printing this built-in model. Using other materials may cause print quality issues and nozzle clogs.
¶ 7.After filament loading is completed, click [Print] to print the built-in test model.
