¶ Initial Print Setup
After unboxing the AD5X, follow these steps for the first startup of the 3D printer.
¶ 1. Plug in the power cord, turn on the power switch, and wait for the screen to respond.
¶ 2.Select your preferred language and click [Next].
¶ 3. Review the on-screen instructions and click [Next].
Tip: You can skip the entire guide by clicking [Skip] to enter the main interface.
¶ 4. Connect to Wi-Fi.
a. Turn on the Wi-Fi switch.
b. Select a Wi-Fi network.
c. Enter the password.
d. Upon successful connection, click [Ok].
¶ 5. Bind to Flash Maker, or click [Skip] or [Next] if you choose not to bind.
a. Use Flash Maker to scan the QR code on the printer screen to bind the printer to your account.
b.After successful binding, click [Next] to proceed.
¶ 6. The printer performs initial calibration.
a) X, Y and Z-axis homing starts. Please ensure the bed nuts are removed before starting.
b) After the extruder and bed reach the target temperatures, 25-point calibration begins.
After the preheating process is finished, the calibration countdown starts.
c) After leveling is completed, it proceeds with XY vibration test. Please ensure the printer is on a stable surface before starting.
d) When the countdown ends, it will automatically proceed to the next step.
¶ 7. Load filament.
Tip: The built-in model is configured for PLA. Please load PLA filament.
a. Manually insert filament into the feed roller. IFS will automatically load it once detected.
b. The screen will display "Filament auto-loading, please wait...".
c. After auto-loading is completed, click [
] to set the filament type and color.
Enter the editing interface.
Choose the filament type.
Choose the filament color.
d. Click [Ok] to save.
e. Repeat Steps a-d for other filament channels. When selecting the filament color, you need to change the corresponding channel manually.
f. After configuring all filaments, click [Next] to proceed.
¶ 8. Start printing.
Printing interface
Printing completion interface
